Press-IN 90 Degree -10AN Power Steering Pump Resivoir Inlet Fitting
This thing was too Expensive
Fit perfectly, solve all the problems having with my LS swap
Awesomeness n billet
Excellent product, my pump was an aftermarket unit so we had to turn a few thousands off for optimal fit, but it works like a champ! Perfect solution straightening out a pile of messy hoses.
Did what was made for
Works well no leaks easy to install
The tip on putting the part in the freezer was very helpful along with the anti-seize. Nice quality part.
Great! No problems what so ever. It solved the problem I was having.
The item is good but I found what I really needed was a straight press in fitting.
Excellent Machined Part
The quality of this part is top notch. The overall finish, quality of the machined radii and the threads were all excellent. I did trim the press fit surface by chucking the part in a lathe with a 4 jaw chuck to get the press fit to about .0015. My pump hole dia. was smaller than the normal. I then stuck the part in my freezer overnight and used a heat gun on the pump and the part tapped in easily with a soft faced mallet. Thanks for solving my plumbing problem!
Great item. Just what I needed due to limited space. Super fit and finish worked super
Fits very close to pump. Perfect for small engine bay.
-10 an fitting
It was great I put the piece in freezer then warmed up pump casting went in so nice and easy end result was great
I didn't want any hose clamps on my power steering system, and this piece worked perfectly! Placed it in the freezer, then gently tapped it into the pump body.
Power steering fix
Great service. Spot on instructions.
Excellent customer service.
Thank you for the Amazing quality